TREVIDEA Girmi GH75 Manual De Uso página 9

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
7. ON/OFF button
10. Water container
FIRST USE
Cut off the power before cleaning your ice-maker. Use a soft fabric to wipe the interiors and exteriors
with neutral cleanser, and then tide the products and wipe the products dry.
Never use organic impregnant, boiling water or washing powder and other stuff that may be harmful to
the products to wash the ice-maker. Also, you should not use the cascade water to clean your ice-maker.
IMPORTANT: place the ice-maker upright on a flat surface for at least 12 hours before using it to allow
the oil contained in the compressor to set down. The same procedure should be followed whenever the
ice-maker has been placed in a non-upright position for whatever reason.
OPERATING
-
Remove ice container (9). Fill water container (8) with max. 2.2 litres of drinkable water. Do not fill
over MAX level. Place again the ice container.
-
Link the plug to the power supply. The light POWER (4) flashes
-
Press ON/OFF (7) to start production. Press SELECT (8) to decide ice cubes dimention.
-
Ice will be produced automatically. To stop appliance you can press ON/OFF (7) in any moment.
-
If the ice full light (1) lights up, the appliance stops. Empty the ice container and press ON/OFF (7);
appliance will restart after few minutes.
-
If the water empty light (2) lights up, the appliance stops. Fill with drinkable water and press
ON/OFF (7); appliance will restart after few minutes.
-
Before unplugging, please wait 2 minutes to let compressor go down in pressure and fully stop.
-
To remove all the water in the water container, place a jug under the draining hole (11) placed
under the appliance, and open the hole removing the cap. Dry water container with a cloth
CLEANING
WARNING: Always unplug the appliance from the electrical outlet before cleaning.
- Do not immerse the appliance and power cable into the water.
- Clean the exterior with a non-abrasive damp, avoid using detergents or abrasive or aggressive
cleaning agents. The cloth should not be too wet, as if the water flows inside the cabinet, it can
seriously damage the unit. Wash the ice container (9) and the shovel rinsing in warm water.
TECHNICAL FEATURES
Power supply: AC 220–240 V ~ 50Hz, 100 W
Automatic production: 12Kg/24 Hours
Gas R600a, 26g
WASTE OF ELECTRIC AND ELECTRONIC EQUIPMENT
The product is made of non-biodegradable and potentially polluting substances if not properly disposed of; other
parts can be recycled. It's our duty to contribute to the ecological health of the environment following the correct
procedures for disposal. The bin symbol indicates the product complies the requirements of the new directives
introduced to protect the environment (2002/96/EC, 2003/108/EC, 2002/95/EC) and must be properly disposed at the
end of its lifetime. If you need further information, ask for the dedicated waste disposal areas at your place of
residence. Who does not dispose of the product as specified in this section shall be liable according to the law.
8. SELECT Button
11. Water drain hole
9. Ice container
12. Ventilation holes
8
loading