Idiomas disponibles
Idiomas disponibles
CONNECTING THE EXTENSION POLE EP7500/EP7500-FC BETWEEN
THE POWER HEAD AND THE POLE SAW ATTACHMENT (Available
Separately)
WARNING:
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
This extension pole is designed for exclusive use with EGO Power Head PH1400/
PH1400-FC and Pole Saw Attachment PSA1000/PSA1000-FC. Never use it with other
EGO attachments.
The extension pole extends the cutting
range. It should to be connected between
the pole saw attachment and the power
head.
Follow the process in the section
"CONNECTING THE POLE SAW
ATTACHMENT TO THE POWER HEAD" to
install the extension pole between the
pole saw attachment and power head
(Fig. 3).
NOTICE:
Once assembled correctly, the pole saw attachment, extension pole and the
power head should not separate when pulled. Always test the connection by pulling on
them. Repeat the steps above if the pieces can be separated.
WARNING:
instructed above could result in serious injury or death.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Press the shaft-release button and, with the button depressed, pull or twist the
pole-saw shaft out of the coupler to separate it from the power head or the
extension pole (if used).
4. Repeat the process to separate the extension pole from the power head
(if extension pole is used).
Never attach or adjust any attachment while the power head is
Failure to secure the attachment and power head/extension pole as
POLE SAW ATTACHMENT — PSA1000/PSA1000-FC
3
Coupler on the Extension Pole
Extension Pole
Coupler on the Power Head
15
