Idiomas disponibles
Idiomas disponibles
6. Hammering only
This rotary hammer can be set to
hammering only mode by pressing the
push button and turning the change
lever to
mark. (Fig. 12)
(1) Mount the bull point or cold chisel.
(2) Press the push button and set the
change lever to middle of
mark. (Fig. 13)
Then rotation is released, turn the grip
and adjust the cold chisel to desired
position. (Fig. 14)
(3) Turn the change lever to
12)
Then bull point or cold chisel is locked.
7. Using depth gauge (Fig. 15)
(1) Loosen the knob on the side handle,
and insert the depth gauge into the
mounting hole on the side handle.
(2) Adjust the depth gauge position
according to the depth of the hole and
tighten the knob bolt securely.
8. How to use the drill bit (taper shank)
and the taper shank adaptor
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 16)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 16)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
mark and
mark. (Fig.
Drill Bit
Change Lever
Push
Button
Fig. 12
Change Lever
Push
Button
Fig. 13
Grip
Fig. 14
Mounting Hole
Knob on
Side Handle
Fig. 15
Grip
Taper Shank
Front Cap
Adaptor
Fig. 16
English
Depth Gauge
15
