Idiomas disponibles
Idiomas disponibles
9IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Safety definitions
9 WARNING
This indicates that death or serious injuries may occur as a
result of non-observance of this warning.
9 CAUTION
This indicates that minor or moderate injuries may occur as a
result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or
property may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or tips.
General information
INSTALLER: Save these instructions for the local electrical
inspector's use. Please leave these instructions with this
unit for the owner. Show the owner the location of the
circuit breaker or fuse. Mark it for easy reference.
OWNER: Please retain these instructions for future
reference.
Check if this blower is recommended by the manufacturer
to be installed with the hood.
WARNING
If the information in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
To avoid electrical shock hazard, before installing, switch
power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
1
CAUTION
FOR GENERAL VENTILATING USE ONLY. DO NOT use
to exhaust hazardous or explosive materials and vapors.
WARNING
To reduce the risk of fire or electric shock, do not use this
blower with any solid-state speed control device.
WARNING
This appliance must be grounded. Improper grounding
can result in a risk of electric shock. Consult a qualified
electrician if the grounding instructions are not completely
understood, or if doubt as to whether the appliance is
properly grounded.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
•
Installation work and electrical wiring must be
done by qualified person(s) in accordance with all
applicable codes and standards, including fire-
rated construction.
•
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
•
USE ONLY METAL DUCTWORK.
•
To reduce risk of fire and to properly exhaust air,
be sure to duct air outside. DO NOT vent exhaust
air in spaces with walls or ceilings or into attics,
crawl spaces or garages.
•
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden
utilities.
