Idiomas disponibles
Idiomas disponibles
Service
• Tool service must be performed only by the MATCO
authorized service centers listed. Service or maintenance
performed by unqualified personnel may result in a risk of
injury . Repair by unqualified personnel, use of unauthorized
parts, and failure to follow maintenance instructions may
create a risk of shock or injury.
SAVE THESE INSTRUCTIONS!
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product
replace strict adherence to cordless product
safety rules. If you use this tool unsafely or incorrectly,
you can suffer serious personal injury.
• Hold tool by insulated gripping surfaces when performing an
operation where the accessories may contact hidden wiring .
Contact with a "live" wire will also make exposed metal parts
of the tool "live" and shock the operator.
• Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical outlet.
• Always be sure you have firm footing.
• Be sure no one is below when using the tool in high locations.
• Hold the tool firmly and use both hands.
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
(See Fig.1, Fig.2)
1. Your new battery pack is not
fully charged. You may need to
charge it before use .
2. Make sure the switch is in the
"off" position before insertion/
removal of a battery pack.
3. To remove a battery pack,
depress both tabs on either
side of the battery and pull
downward .
4. To insert a battery pack, align
the battery with the tool
housing and push battery
inward until click indicating
battery is fully installed .
Charging The Battery Pack
(See Fig.3)
1. Battery may not charge when it is above a certain preset
temperature limit. Allow temperature of battery to cool before
charging .
2. The charge process will take less than one hour.
3. After charging, unplug the charger from the power source and
stow away in a safe place .
MCL12MP
MCL12MP 12V 3" MINI PISTOL GRIP POLISHER
Fig. 1
Fig. 2
Fig. 3
• Keep hands and hair away from rotating parts.
• Do not leave the tool running. Do not force tool to stay in the
"on" position. Operate the tool only when hand-held.
• Do not touch the accessory or the workpiece immediately after
operation; they may be extremely hot and could burn your skin.
• Some material contains chemicals which may be toxic. Take
caution to prevent working dust inhalation and skin contact.
Follow material supplier safety data .
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Tool Operation
1. Tighten backing pad in a clockwise direction using the
included spanner wrench .
2. Attach polishing pad or fine sanding paper to the backing
pad . Center properly .
3. Press trigger to activate.
4. For removal of velcro pad attachment use wrench key to fix
the shaft and turn the velcro pad attachment in counter
clockwise direction.
WARNING: During operation, safety goggles should always
be worn to guard against flying rust & chips (users &
bystanders).
3
07/13/15
