Idiomas disponibles
Idiomas disponibles
Unpacking
Carton Contents
• Sprinkler head
• Sprinkler connector
• Sensor housing
• Post
• Step spike
• Hose quick-connector
• Optional predator sticker
• Manual and registration card
• Hose-end connector
• Extended spike
1. Carefully remove the pest deterrent
sprinkler and check to see that all of the
above items are supplied.
2. Inspect the product carefully to make
sure no breakage or damage occurred
during shipping. If you find damaged or
missing parts, DO NOT return the unit
to the store. Please call the Snow Joe
+ Sun Joe
customer service center at
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton
and packaging materials until you are
ready to use your new pest deterrent
sprinkler. The packaging is made of
recyclable materials. Properly dispose of
these materials in accordance with local
regulations.
IMPORTANT! The equipment and packaging
materials are not toys. Do not let children play
with plastic bags, foils, or small parts. These
items can be swallowed and pose a suffocation
risk!
Assembly
No Tools Required
1. Set the detection mode to
battery cover (located under the sensor
housing), then snap the battery case onto
the battery clip connector (Fig. 1) and close
the battery cap clockwise until the click
sounds (Fig. 2).
m
WARNING!
liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery
may cause irritation or burns. may cause
irritation or burns.
. Open the
Under abusive conditions,
m
WARNING!
or appliance that is damaged or modified.
Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion
or risk of injury.
m
WARNING!
battery pack or appliance to fire or excessive
temperature. Exposure to fire or temperature
above 265°F may cause explosion.
Fig. 1
Battery clip
connector
®
Fig. 2
2. Run a dry test by turning the detection
mode to
the sensor lens. You should clearly hear the
internal water valve click open, then click
closed 3 seconds later.
If this does not work, try a new battery. The
sprinkler resets 8 seconds after the valve
closes if the sensor does not detect any
further motion.
3. Follow (Fig. 3) to assemble your pest
deterrent sprinkler. These fittings should
only be hand-tightened. No tools are
required.
3
Do not use a battery pack
Do not expose a
Detection
mode
Battery case
and wave your hand in front of
