Idiomas disponibles
Idiomas disponibles
Reversing the Door Hinge
1. Remove the top hinge cover screw and then remove the top hinge cover.
2. Using a Phillips Head Screwdriver, loosen and remove the screws holding the top
3. Remove the top hinge and carefully lift off the door.
4. Remove the screw holes plugs and door plug from the opposite side and insert the
5. Remove the door pin from the bracket of the lower hinge by turning counter
ZARD
6. Loosen the screws holding the lower hinge bracket and remove the hinge.
7. Remove screws on opposite side of the cabinet and align the lower hinge bracket
8. Align the bottom hole on the left side of the door with the pin of the lower hinge
9. Align the pin of the top hinge with top hole on the left side of the door and push
10. Make sure the door closes easily but forms a tight seal. Adjust the door as
11. Replace the hinge cover, insert the screw and tighten completely. (see fig. # 2)
12. If the door does not close properly, refer to the section titled "Door Alignment".
All manuals and user guides at all-guides.com
(see fig. # 1)
hinge in place. (see fig. # 1)
plugs in the screw holes openings of the just removed screws. (see fig. # 2)
clockwise. Move the pin to the opposite hole and tighten. (see fig. # 3)
(see fig. # 3)
with holes.
and slide into place.
fig. 2
into place. Replace the screws in the upper hinge bracket but do not tighten all the
way. (see fig. # 2)
needed. Once you are satisfied with the door alignment, completely tighten
the upper door hinge screws.
fig. 3
screws
screw holes plugs
door pin
lower hinge bracket
English
6
