Section 2 - Installation
Step 6
Place the baseplate at the desired location, assuring that it is placed where close enough for the
cord to reach a power outlet. Make sure the release tab facing up. Use a pencil to mark the holes.
Step 7
Using a 6 mm drill bit, drill two 25 mm deep holes over the pencil marks. For a plaster, drywall, or
concrete wall, insert the plastic anchors to support the screws first.
Step 8
Place the baseplate over the holes. Use the supplied screws to attach the baseplate to the wall.
D-Link DCS-8600LH User Manual
Mounting the Power Supply
6
2 7
8
12
