Idiomas disponibles
Idiomas disponibles
Press and hold down this
tab on the wire connector
and pull the connector apart.
Figure 9
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 10. Set the gasket
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack.
OVERLAY DOOR PANEL INSTALLATION
Holes in
gasket
retainer.
Figure 10a
Figure 10
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 11 to 18.
13
Overlay panel
flush with top
of door.
Overlay panel
to overhang
⁄
"
3
16
(5 mm) on each
side of door
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.
