Idiomas disponibles
Idiomas disponibles
1. If you convert the stove from natural gas to propane gas or LPG, unscrew the sealing screw on the
bottom of the pilot pilot, then remove the pilot nozzle with the feature 40 and screw in the nozzle with
the feature 20 all the way (in case of propane or LPG, the same nozzle is used). Then screw in the sealing
screw. (Fig 16 item 5) Light the pilot burner. The ame should heat the thermocouple and burn with the
bright ame. If this is not the case, adjust the air ow using the shutter at the top of the pilot.
2. If you convert the stove from propane gas or LPG to natural gas, proceed as described in point ‚a' ,
and then screw out the pilot nozzle with the feature 20 and screw in the jest with the feature 40 as the
way.
1
2
3
Figure 16. onstruction of the burner on the example of 7kW burner.
Attention! After conversion of the stove to another type of gas, stickers packaged with the nozzles, specify-
ing the type of gas for which the stove is adapted, should be put on the nameplate and the warranty card.
Example: Convert the stove adapted to combustion of LPG into combustion of natural gas. After the co-
nversion, the sticker G20 2E (20mbar) packaged with the nozzles should be put on the name plate (Fig.15
item 1, Fig.17)
The gas part
9. Country
10. Category
11. Supply pressure
12. Type
13. Nominal heat load
14. Gas consumption depending on the type of supply gas
15. Gas/pressure adapted device
4
5
1. Head of burner
2. Burner body
3. Injector with shutter
4. Pilot burner
5. Sealing screw
Figure 17. Example of the nameplate
- 42 -
1. Model
2. Catalogue code
3. Serial number - year of manufacture
4. Degree of protection
5. Net weight
Electrical part
6. Voltage
7. Frequency
8. Electrical power
