Fellowes Powershred H-7C Manual De Instrucciones página 2

Idiomas disponibles

Idiomas disponibles

A.
B.
C.
D.
E.
For safety reasons, shredder will operate
only if the shredder head is in correct
position and used with supplied basket.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples and small paper clips
Will not shred: Unopened junk mail, continuous forms, adhesive labels,
transparencies, newspaper, cardboard, large paper clips, laminates, file folders,
X-rays or plastic other than noted above
Paper shred size:
Cross-Cut ..........................................................5/32 in. x 1-3/8 in. (4mm x 35mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
in the instruction manual. Read the entire instruction manual
before operating shredders.
paper entry. Always set to off or unplug when not in use.
away from shredder openings. If object enters top opening,
switch to Reverse (
Never use aerosol products, petroleum based lubricants or other
flammable products on or near shredder. Do not use canned air
on shredder.
shredder. Do not place near or over heat source or water.
2
F.
G.
) to back out object.
KEY
A. Paper/card entry
G. Control switch and LEDs
B. Shredder head
C. See safety instructions below
D. Bin
E Window
F. Safety lock
To set lock slide
button down
Maximum:
Sheets per pass .....................................................................................................7*
Cards per pass .......................................................................................................1*
Paper width .....................................................................................8.7 in. (220mm)
*8.5"x11", 20lb., (75g) paper at 120V, 60Hz, 2.0Amps; heavier paper, humidity or
other than rated voltage may reduce capacity. Maximum recommended daily usage
rates: 50 sheets; 5 cards.
amperage designated on the label. The outlet or socket must be installed
or extension cords should not be used with this product.
ENGLISH
Model H-7C
1. Reverse
2. Off
3. Auto-On (green)
4. Overheat (red)
loading