Idiomas disponibles
Idiomas disponibles
9.2. Pressure, flow rate and autonomy of each nozzle
type
Nozzle
Level
Pressure (psi)
Min.
01
Med.
(ORANGE)
Max.
Min.
02
Med.
(YELLOW)
Max.
NOTE*: The values above may vary as to the wear, clogging and variation of the
nozzles, the density and viscosity of the liquid to be applied, the temperature and
relative humidity of the environment, the altitude and consequent atmospheric
pressure of the site, the height of the lance spraying, etc.
NOTE**: The minimum working nozzle pressure should always be observed, so
we do not recommend spraying at pressures below 15 psi for fan nozzles and
below 45 to 60 psi for conical nozzles depending on the model. In addition, we
do not recommend using ISO standard nozzles of brown color (05 gal/min at 3
bar pressure).
9.3. Shoulder strap adjust
1.
Mount the strap belt onto the tank as shown in position A.
2.
Finally, adjust the intermediary buckle as desired, as shown in B. To tighten
the strap belt, hold the strap buckle firmly with one hand and pull the
handle.
B
9.4. Turn On/Off the sprayer
Note: Before starting to spray, retighten the hose clamps to avoid contamination
of the operator and of the environment.
To turn on the sprayer:
1.
Turn on the sprayer using the ON/OFF switch in the electric panel.
2.
Place the lance with the trigger valve pressed above the base of the
sprayer until the spray jet begins to spray continuously.
3.
Direct the spray lance to a safe position and open the trigger valve to
begin spraying.
To turn off the sprayer:
1.
Shut off the trigger valve. The internal pump pressure switch will automa-
tically turn off the pump (the sprayer is said to be in idle state).
2.
Turn off the sprayer using the ON/OFF switch in the electric panel.
3.
Direct the spray lance to a safe position and open the trigger valve to rele-
ase pressure before storing the sprayer.
8/39
Flow rate
Autonomy
(L/min)
(h)
30
0,38
13,0
46
0,44
8,9
61
0,50
5,6
15
0,58
14,6
27
0,72
8,5
39
0,84
5,6
A
9.5. Filling the spray tank with pesticides
1.
Read carefully the chemicals manufacturer's labels;
2.
Put 5 liters of water in a bucket and add the chemical product;
3.
Stir until it becomes an homogeneous mixture;
4.
Pour the solution into the tank while filling with water.
9.6. Application
Wear appropriate protective clothing
Do not contaminate water
Spray downwind and
avoid drift
9.7. PPE
WARNING!
In case of an accident remove the sprayer immediately as
shown in the illustration below.
WARNING!
Do not spray near people who are not using PPE or near
springs, lakes or rivers.
Keep constant height
