HQ-Power VDPDMXC174 Manual Del Usuario página 5

3. Verify that the speed and fade time sliders are positioned at zero.
4. Press the scanner button corresponding to the unit you wish to control. You may control more than one
scanner at a time by pressing the button corresponding to the scanner(s) you wish to program.
5. Move the faders and the joystick to the desired position. If necessary, you may select page B to control
channels 9 ~ 16.
6. Tap the bank UP / DOWN button to choose the bank you want to store this scene into. There are a total of 30
banks you can select from. You may store up to 8 scenes in each bank.
7. Once all scanners are programmed into the desired position for one scene, tap the MIDI / REC button to
program this scene into the memory.
8. Tap the scene button you wish to store your scene into. All LEDs will flash three times. The LCD readout will
show the bank and scene.
9. To unselect the scanner(s) you have been programming and to switch to another scanner, simply press the
button of the scanner you have been programming again, deselecting it, and select another scanner.
10. Repeat steps 2 to 7 until all scenes have been programmed.
11. If you do not intend to continue programming at this time, press and hold the PROGRAM button for three
seconds to exit PROGRAM mode. The LED will go out indicating this selection.
• Example of a Scene Programme
1. Enable the PROGRAM mode.
2. Tap the SCANNER 1 button to turn on its fader control.
3. Verify that the page is set on page A. If not, press the PAGE SELECT button to select page A.
4. Move the first and second faders all the way up to their maximum value position.
5. Select bank 1 using the bank UP / DOWN buttons.
6. Press the MIDI / REC button.
7. Tap scene 1 to store the first scene.
8. Repeat steps 4 to 7 until all scenes have been programmed into bank 1.
9. Tap the SCANNER 1 button to turn off the fader control.
10. When finished, disable the PROGRAM mode. You can now manually tap through what you have just
programmed.
• Editing a Scene
1. Enable the PROGRAM mode.
2. Press the bank UP / DOWN button to select the bank containing the scene you wish to edit.
3. Select the scene you wish to edit by tapping its scene button.
4. Use the faders and/or joystick to make the desired adjustments to the scene.
5. Once you have completed the changes, tap the MIDI / REC button.
6. Tap the scene button that corresponds to the scene you're editing. This will override the existing scene.
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an existing scene.
• Copying Scanner Settings
This setting allows you to copy the settings of one scanner to another.
1. Press and hold down the scanner button you wish to copy.
2. While holding down the button, tap the button of the scanner you wish to copy the settings to.
• Copying a Scene
1. Enable the PROGRAM mode.
2. Tap the bank UP / DOWN button to select the bank containing the scene you wish to copy.
3. Select the scene you wish to copy by pressing its scene button.
4. Using the bank UP / DOWN button select the bank you wish to copy the scene to.
5. Tap the MIDI / REC button.
6. Tap the scene button you wish to copy the scene to.
VDPDMXC174
5 VELLEMAN