Idiomas disponibles
Idiomas disponibles
Cooling
1. Press the button "mode" (figure 1, g) once or multiple times, until the indication light lights up at "cool".
The device is now functioning as air cooler, and will cool the air by means of a cooling element.
2. Use the buttons "up" (d) and "down" (e) to set the cooling temperature between 16°C and 31°C.
3. Press the button "speed" (c) to switch between a low or high speed of exhaust air. The indication light
lights up at "low" (low speed) and "high" (high speed).
USAGE - Sleep function
The device has a sleep function. If you turn on this function, the device will operate in its most silent and
energy saving mode. Attention: the sleep function only works in the "COOL" mode
1. Press the button "sleep" (figure 1, f) to turn on the sleep function. The device switches to the lowest and
most energy saving mode.
2. Press the button "sleep" again to turn off the sleep function.
USAGE - Timer function
The device has a time switch with which you can automatically turn the device on or off at the end of a set
time.
Automatically turning on
When the device is turned off:
1. Press the button "timer" (figure 1, b). The display starts to flicker.
2. Use the buttons "up" (d) and "down" (e) to set the switch-on time between 1 and 24 hours.
3. Wait until the display (a) stops flickering. The switch-on time is set.
4. Press the button "timer" again to adjust the switch-on time if desired.
5. Press the button "timer" again to turn of the timer function.
Automatically turning off
When the device is turned on:
1. Press the button "timer" (figure 1, b). The display starts to flicker.
2. Use the buttons "up" (d) and "down" (e) to set the switch-off time between 1 and 24 hours.
3. Wait until the display (a) stops flickering. The switch-off time is set.
4. Press the button "timer" again to adjust the switch-off time if desired.
5. Press the button "timer" again to turn of the timer function.
USAGE - Remote control
The device can also be controlled with the included remote control. The remote control requires two AAA-
batteries (not included). Open the battery compartment on the underside, place the batteries, and close the
lid. The buttons on the remote control function the same as the buttons on the control panel.
For an optimal functioning:
•
Make sure the distance between the ventilator and the remote control is not more than 6 metres.
•
Aim the remote control at the device and make sure the direction angle is smaller than 30 degrees.
CLEANING AND MAINTENANCE - General
After a period of time, dust can get into the rosters and the slats of the device.
1. Turn off the device and pull the plug from the socket.
2. Remove the dust of the rosters and slats with a hand brush and/or vacuum cleaner.
3. Clean the casing with a soft, moist cloth. Never immerse the device in water. Make sure no moist can
get into the electrical connections.
45
EN
