Idiomas disponibles
Idiomas disponibles
C
onnecting Water Supply Hose
Before connecting the Water Supply Hose to the water tap, check the hose type and then
choose the correct instruction here under.
Note that the Water Supply Hose supplied may vary from country to country. Make sure to
connect the blue inlet hose to the COLD water tap, and the orange inlet hose to the HOT
water tap.
Screw Type
1
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
packing within the hose can adhere completely to
the tap.
2
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and
then tighten it by screwing it to the right.
3
Check water leakage.
After connecting the hose, open the tap to check
for any water leakage.
Connecting Water Supply Hose to the machine
• Connect the water supply hose to inlet valve
of the washing machine, and then lock it by
turning the hose connecting part.
• Check to see if there is a rubber seal inside
the connector.
• The appliance must be connected to the
water main inlet, using a new set of hoses;
considering not to reuse old hoses which
are in poor condition.
Water
tap
Rubber Packing
Water Supply Hose
Hose connector
Rubber seal
27
