Idiomas disponibles
Idiomas disponibles
Assembly
(Continued)
• Save all instructions
C
Debris Guard:
1 . Insert the tab on the metal mounting bracket into the
slot on the debris guard . (Fig . 5-6)
2 . Install the hex head cap screw through the bracket
and into the metal insert of the debris guard .
Tighten securely using a 10 mm wrench . (Fig . 7-8)
CAUTION
The trimmer line knife attached to the debris guard is
sharp and can cut you . Handle with care .
D
Wheel Assembly:
1 . Install the right wheel to the frame using the longer
shoulder screw and spacer . Tighten to 25 ft . lbs .
(34 N .m) torque using a 14 mm wrench . (Fig . 9-10)
2 . Install the left wheel to the adjuster assembly stud
using the shorter shoulder screw . Tighten to 25 ft . lbs .
(34 N .m) torque . (Fig . 11 & 12)
3 . Move the bevel handle to the low position for
level mowing .
E
String Storage:
1 . Snap the lower tube clip onto the left middle handle
using the pierced hole . (Fig . 12)
2 . Snap the upper tube clip onto the left middle handle
above using the pierced hole .
3 . Install the clear tube with provided extra string
into the clips . (Fig . 13)
Questions? Call Toll Free at 1-800-737-2112
SLOT FOR
BRACKET TAB
SPACER
ADJUSTER
ASSEMBLY
TUBE CLIP
EN-6
Copyright © 2017 MAT Engine Technologies, LLC
DEBRIS
METAL MOUNTING
GUARD
BRACKET
Fig. 5
METAL MOUNTING
HEX HEAD
BRACKET
CAP SCREW
Fig. 7
SHOULDER
SCREW
Fig. 9
Fig. 11
TOP CAP
Fig. 12
Fig. 6
HEX HEAD
CAP SCREW
Fig. 8
Fig. 10
SHOULDER
SCREW
(SHORTER)
BEVEL
HANDLE
Fig. 12
UPPER
CLIP
LOWER
CLIP
Fig. 13
