Idiomas disponibles
Idiomas disponibles
Assembly
• Save all instructions
Parts Included With The Packaged Trimmer:
•
Operator's Manual
•
Upper and Middle Handles
•
Trimmer Guard
•
Spark Plug Wrench
•
Replacement String Tube and Clips
•
50:1 2-Cycle Engine Oil (2 .6 Fluid Ounces .)
•
Front Tube with Trimmer Head
•
(2) Wheel Assemblies
WARNING
Do not operate Trimmer if it is damaged or not securely and fully assembled .
Tools Needed For Assembly:
•
10 mm wrench or adjustable wrench
•
14 mm socket or open wrench
Unpacking:
1 .
Remove components from carton .
2 .
Cut white cable ties . Do not cut black cable ties .
3 .
Remove foam and corrugated protection .
A
Handle Assembly:
1 . Install middle handle to lower handle and secure
using two saddle bolts and plastic knobs . Orient
handle so small metal clips are to the right side .
Route pivot cable through middle handle . Assemble
with knobs to the inside of the lower handle . Tighten
knobs securely . (Fig . 1)
2 . Install upper handle to middle handle and secure using
two saddle bolts and plastic knobs . Orient handle so
the "V" shape is upward . Assemble with knobs to the
inside of the middle handle . Route the throttle cable
below the right side of the middle handle . Tighten
knobs securely . Secure throttle cable to the handles
with provided metal clips as shown . Secure the pivot
cable with provided plastic cable tie . (Fig . 2)
B
Cutting Head Assembly:
1 . Install the cutting head assembly into the
clutch housing with the metal saddle engaging the
clutch housing . (Fig . 3) It may be necessary to rotate
the trimmer head slightly to align the shaft splines .
2 . Screw the camlock inward and rotate the handle
to clamp the tube to the housing . Try to rotate the
tube within the housing . If you can rotate the tube
at all, unlock the camlock handle and screw inward
an additional one half turn . Rotate the handle to
clamp the tube . Recheck for tube tightness and
repeat if necessary . (Fig . 4)
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing,
CALL TOLL FREE: 1-800–737-2112
•
(4) Plastic Wing Nuts (For Attaching Handles)
•
(4) Saddle Bolts (For Attaching Handles)
•
(2) Cable Ties
•
(1) Wheel Shoulder Bolt (Longer for Right Side Wheel)
•
(1) Wheel Shoulder Bolt (Shorter for Left Side Wheel)
•
(1) Wheel Spacer (For Right Side Wheel)
•
(1) Hex Head Cap Screw (For Attaching Trimmer Guard)
MIDDLE
HANDLE
LOWER
HANDLE
CUTTING HEAD
ASSEMBLY
EN-5
Copyright © 2017 MAT Engine Technologies, LLC
UPPER
HANDLE
MIDDLE
HANDLE
Fig. 1
Fig. 3
Fig. 2
Fig. 4
