Adjusting The Lid Counter-Balancing; Replacing Parts; Instructions And Warnings For The Replacement Of Part; Equipment Decommissioning, Demolition And Disposal - Angelo Po 1N1PI1E Manual De Uso

To carry out this operation, proceed as follows.
Fit the spanner (A) onto the hexagon (B).
1)
Keep a fi rm grip on the spanner (A) and undo
2)
the locking screws (C).
Turn the spanner (A) clockwise to load the
3)
spring or anti-clockwise to release it ( left
hand) and anti-clockwise to load the spring or
clockwise to release it ( right hand).
C
B
A

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PART

The appliance does not require the replacement
of operating components by specialist staff
except the replacement of standard parts which
can be carried out by the user.

EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL

When decommissioning the appliance, a series
of procedures must be carried out to ensure
that the appliance and its components are not a
hindrance and are not easily accessible.
To ensure that the appliance cannot constitute
hazards for people or the environment, all energy
sources (electricity, etc.) must be disconnected
and rendered unusable, and any liquids present
must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not
easily accessible, with barriers to prevent anyone
from accessing it.
3320140_inst_GB_rev.1

ADJUSTING THE LID COUNTER-BALANCING

REPLACING PARTS

Once the correct balance is obtained, screw in
4)
the screws (C) without tightening them fully.
the spanner (A) to turn the shaft until it is
5)
located in one of the seats provided.
Fully tighten the screws (C).
6)
When scrapping, sort all components by chemi-
cal characteristics and dispose of them separately
in accordance with the relevant legal require-
ments.
Important
Do not dump non-biodegradable
products, lubricating oils, and non-metallic
components (rubber, PVC, resins, etc.) in the
environment. Dispose of them in compliance
with the relevant laws.
- 13 -
C
B
A
ENGLISH
GB