Idiomas disponibles
Idiomas disponibles
INSTALL THE ACCESSORIES
1. Install the crevice nozzle
You can use the vacuum cleaner with the multifunction nozzle (8), to reach
the most difficult corners, under furniture, for cleaning the upholstery (sofa,
bed, armchairs) or for cleaning the car.
Proceed with the installation of the nozzle (8) directly to the power unit as shown in Fig 1. Add the tubes (2)
in case you need to reach fa surfaces like the ceiling. Mount the nozzle (8) to the tube (2), and the tube to the
motor housing. To remove the nozzle, press release button (3) and pull.
2. Install tube and floor brush
Use the tubes (2) to connect the floor brush (1).
Insert the tube (2) in the suction hole until blocking, then connect the
brush (1) to the lower part of tube (2).
You can mount only one or both tubes included. To remove the tube,
press release button (3) and pull.
3. Remove the dust bin
Press the release button (9) and pull the container extracting from motor housing.
4. Install the dust bin
Insert the pin present on the container inside the lock present in the motor housing. Push the container one the
motor housing until blocking.
SWITCH ON THE UNIT
-
Connect the plug. Take the product in your hand and turn it on by pressing the button (4).
-
Always turn off the appliance before unplugging and putting it away.
CAUTION: the vacuum cleaner is powerful. Hold it firmly to prevent it from falling causing damages
or personal injury.
EMPTY THE CONTAINER
In order to ensure the best performances and having no losses in the air flow and
cleaning power, periodically drain the container.
CAUTION: before emptying and/or start cleaning the dust bin, unplug the unit
from the main electrical outlet.
To empty the container, extract the container, take it above a bin and press the release button
(7) as shown in Figure 3. This button will open the door dropping all the dirt. It is
recommended to do this outdoors to avoid soiling the house when the dust comes out of the
trash. Close the lid.
CLEANING FILTERS
This vacuum cleaner is equipped with a metallic filter (a) and 1 HEPA filter (b), capable of
retaining particles and small organisms such as mites and pollens. In this way the air re-
emitted from the cleaner will be more healthy and clean. To maintain the performance of the
vacuum cleaner is recommended to clean the filters regularly.
- Release the container (5) and clean it, as described in the previous paragraph.
- Take the filtering system out of dust container.
- Go over a bin and take out the HEPA filter (b), pulling it out of filtering system (a).
a) The filtering system with metal mesh filter can be washed with running water.
b) Clean HEPA filter as described below.
Linked to the HEPA there is a black sponge filter: take it and shake in a bin.
At least once a week, shake the HEPA filter in the bin to get the dirt out.
At least once every 2 months, carry out a more thorough cleaning: rinse HEPA filter, metal
12
