Idiomas disponibles
Idiomas disponibles
5.
IMPORTANT TEST FOR LEAKS:
This must be carried out in a well-ventilated area, free from naked flames and any other sources of
ignition. With the regulator connected to the cylinder turn on the regulator control. Brush all hose
connections, pipe connections to the valve and gas cylinder valve with a 50:50 solution of
detergent and water. A stream of bubbles forming indicates a leak. If a leak is found turn off at the
regulator and disconnect the regulator from the bottle and remove the gas cylinder outdoors or to a
well-ventilated area. Contact your gas supplier for assistance. DO NOT USE THE HEATER.
6. After leak testing is satisfactorily carried out close the back door of the heater. It may be necessary
to move the heater slightly to allow the regulator and hose to fit in the back without kinking the hose.
HOW TO CHANGE A CYLINDER
1. Unplug the heater before take out the cylinder.
2. Turn off at the regulator and allow the heater to cool fully before removing and replacing the cylinder.
Do not attempt to replace the cylinder whilst the heater is still running.
3. Cylinders must be replaced in a flame free environment.
4. Do not smoke while changing the cylinder.
5. When you need to replace your empty cylinder, turn the gas off at the valve or regulator of the
cylinder and take the empty cylinder out of the heater.
6. Remove the regulator from the empty cylinder.
7. Following the steps described under "connecting the cylinder", connect a new cylinder.
ELETRIC QUARTZ OPERATION GUIDE
(a) Take out the heater from the carton carefully. Please save the carton for off–season storage.
(b) Make sure the heater in off position "O" before switching on.
(c) Connect to a cylinder with a regulator and hose (not supllied).
GAS HEATER OPERATION GUIDE
Pos. 1
Pos.2
- 30 -
Pos.3
