Idiomas disponibles
Idiomas disponibles
Other
Settings
Language
Time stamp
Battery Type
Frequency
Cycle recording
Password
Reset
FW Update
QR Code
About
9. Setting up the camera
− Mount the camera facing north or south, not east or west as the rising and setting of the sun could
produce false triggers and overexposed images.
− If you're covering a trail, face the camera down or up the trail.
− Clear out any brush or weeds in front of the camera. These can cause false triggers due to temperature
and motions disturbances in front of the camera (especially in windy days).
− Check the power level of the batteries.
− Make sure the memory card is properly inserted and have sufficient available space.
− Verify time and date are correct.
Programmable options (default settings in bold characters)
Français | Español | Deutsch | Italiano | English
OFF | ON
Select "ON" if you want the date and time of the image capture imprinted on
every photo. The current temperature, moon phase, user set camera ID and GPS
coordinates (if the "GPS" parameter is set to ON) will also be imprinted on the
still photos.
Alkaline | Ni-MH (nickel-metal hydride)
The device will perform better and have better battery life if you select the type
of the batteries used in the camera.
50Hz | 60Hz
An improper setting may cause the camera screen to flicker.
OFF | ON
When the memory card will be full, the camera will continue to record
photos/videos by deleting the oldest photos/video.
Select "OFF" then press OK to deactivate the cycle recording function.
OFF | ON
Select "ON" then press OK to enable password protection for your camera
(6 digits/letters).
No | Yes
Select "Yes" to reset the camera back to the factory default settings.
Allows you to update the camera firmware.
Allows you to view the QR code of the device if you need to pair it again with the
application.
This parameter shows the following information: Ver | IMEI | MCU | MOD
Guide d'utilisation PIE1058 – indice A – Janvier 2023 - 28/72
