Idiomas disponibles
Idiomas disponibles
GB
OPERATION
TSL
A
C
E
B
D
F
With the hood switched off, pressing any key will activate the control panel in stand-by mode. The
symbols are backlit by a white light, allowing you view and select the desired function.
Pressing one of the keys again will start the corresponding function, and its symbol will light up. After all
functions have been switched off, the control panel will remain in stand-by mode for around 30 seconds
and then switch off automatically.
A: Light ON/OFF key: press this touch sensor to switch on or off the lights of the hood.
C: Motor ON/OFF key (4 speed): press this touch sensor to switch on the hood extractor fan at the same
speed as it was when last switched off. Use the „D" and „B" keys to vary the speed (power) of extraction.
B: Decrease extraction speed (power) key: press this touch sensor to reduce the extraction speed of the
hood.
D: Increase extraction speed (power) key: press this touch sensor to increase the extraction speed of the
hood.
E: Timer key: when this touch sensor is pressed, independently of the extraction speed selected, the
timer function will be activated. Press once to set the timer for 5 minutes, press a second time for 10
minutes and a third time for 20 minutes. During this phase, the „E" symbol will flash.
To reset the timer, press the motor key, „C"
F: Reset filters key: press this touch sensor to reset the signal that warns that the metal grease filter (1)
is saturated and the charcoal filter (2) should be replaced. (1) After 40 hours of using the hood, the „F"
symbol will flash to indicate the necessity of cleaning the metal grease filters.
(2) After 120 hours of using the hood, the „F" symbol will light up to indicate the necessity of replacing
the activated charcoal filters.
Note: 4 hours after the last key touch, the fan will automatically turn off.
All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for 7 minutes, after
which it automatically returns to the last non-timed speed.
22
