Idiomas disponibles
Idiomas disponibles
Tefen MixRite TF 25 Fertilizer and Chemicals Injector
Congratulations on your purchase of one of Tefen's high quality products.
To get the best results from the MixRite TF-25 Proportioning Dosing Injector it is important to
spend a few minutes reading carefully the explanations and recommendations in this users manual.
Operating princip
The proportioning dosing injector is fitted on the water line. The flow of water passing through the
injector activates it and causes the pumping of liquid fertilizer (or other additive) and inject it in a
relative quantity into the water line.
The MixRite TF 25 technical working range:
The flow rate of water passing through the injector is between 3 and 25 m³/Hr. (9 – 110 GPM).
The water pressure is between 1 and 8 bar (14.7 and 120 PSI).
The water and air temperatures are not less than 4°C and not more than 40°C (39°F - 104°F).
Head loss: Low flow 0.2 Bar – High flow 1.5 Bar.
Max deviation injection rate +/- 10%.
Before using, an initial calibration should be done, in order to assure accurate match with the
injector printed scale.
The flow rate of the fertilizer and chemicals can be adjusted relative to the flow rate of the water in
the range of:
0.1% to 1%
0.2% to 2.5%
0.5% to 5.5%
Installing the Injector
Check that Injector package contains the following items:
* One proportioning dosing injector to which are attached
Two compression fittings (Plasson) for a 63 mm PE pipe
or two BSPT 2" or NPT 2" threaded couplings according to
the model.
* One flexible suction tube to which is attached a flat seal
And a filter.
* A stand comprising 4 legs, 2 arched braces, 4 bolts with
8 mm nuts.
* Wall bracket.
* Spanner for TF cover nut.
* One User's manual.
To fit to wall – connect one of the brackets to the
wall by inserting 4 screws in the Bracket.
TEFEN
TEFEN Advanced Plastic Solutions.
2
