Idiomas disponibles
Idiomas disponibles
English
Auto-Scan Function
Press [Ctrl] + [Ctrl] + [S] + Enter to activate the Auto-Scan function; the KVM will cycle through the 2 display ports
sequentially.
Press [Ctrl] + [Ctrl] + [S] + [n] + Enter to adjust the time interval during Auto-Scan, where [n] can be 5 ~ 999.
Press any other key on the keyboard to turn off the Auto-Scan function.
Buzzer Function
Press [Ctrl] + [Ctrl] + [B] + [1] to enable the buzzer function. (Default)
Press [Ctrl] + [Ctrl] + [B] + [0] to disable the buzzer function.
The buzzer sound:
(a) activate leading hotkey beeps once;
(b) accomplish setting hotkey and Enter beeps once;
(c) error hotkey beeps once and quit;
(d) only press leading hotkey in a few seconds without further step beeps once and quit.
Hotkey Summary
Step 1
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
Ctrl
The two-step hotkey sequence is used for quick function execution. The leading key (Step 1) is [Ctrl] + [Ctrl] by default.
However, you may change the leading hotkey if you want, by pressing [Ctrl] twice, [H] + mode A or B (see below), then
pressing Enter. The available leading hotkey modes are shown below.
Set leading hotkey to mode A (for Mac keyboard only):
Press and hold [Command] + [F12] + [F12] + release [Command]
Set leading hotkey to mode B:
[Ctrl] + [Ctrl]
Support Delock
If you have further questions, please contact our customer support [email protected]
You can find current product information on our homepage: www.delock.com
Final clause
Information and data contained in this manual are subject to change without notice in advance. Errors and misprints
excepted.
Copyright
No part of this user manual may be reproduced, or transmitted for any purpose, regardless in which way or by any
means, electronically or mechanically, without explicit written approval of Delock.
Edition: 01/2023
Step 2
Enter
[A]+Enter
[Z]+Enter
[D]+Enter
[P]+[W]+[ 1/0]
[S]+Enter
[S]+[n]+Enter
[B]+[1/0]
Action
Switch to next host (PC + USB Hub + Audio)
Switch Audio to next Host
Switch USB Hub to next Host
Switch DP to next Host (PC only)
Enable / Disable Host USB power detect
Start Auto-Scan
Auto-Scan time interval (Default: 20 sec)
n=5~999 sec
Enable / Disable buzzer
-4-
