Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Warranty ...................................................
Pre-Installation
.....................................
....................................
Tools Required
.....................................
Hardware Included
..................................... 4
Package Contents
Safety Information
IMPORTANT SAFETY INSTRUCTIONS
WHEN INSTALLING OR USING THIS LANDSCAPE SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE
FOLLOWING:
Read all instructions prior to beginning the installation process.
□
All electrical connections must be in accordance with local codes
□
and the National Electrical Code. If you are unfamiliar with methods
licensed electrician.
This power pack is for use with low-voltage landscape lighting
□
systems ONLY.
□
Suitable for use with submersible luminaries and pumps.
□
DO NOT submerge the power pack in water.
DO NOT connect two or more power suppliers in parallel.
□
□
DO NOT use the power pack with a dimmer switch.
Always disconnect the power pack from the electrical outlet
□
when working on the lighting system.
Power pack MUST be installed at least 20 in. above ground level.
□
□
DO NOT exceed the maximum wattage of the power pack's terminal.
For use only on a branch circuit protected by a Class A-type
□
ground fault circuit interrupter (GFCI).
□
ONLY connect the transformer cord to a covered 120-volt Class A
type cover plate outlet that is marked "WET LOCATION".
□
DO NOT repair or tamper with cord or plug.
□
A cord-connected landscape lighting system shall not be used
with an extension cord.
The power pack has a 30-watt circuit that powers up to 30 watts
□
of light.
□
This device is accepted as a component of a landscape lighting
□
system where the suitability of the combination shall be determined
by UL or CSA or local inspection authorities having jurisdiction.
□
Ensure that the power unit and cord do not interfere with
completely closing the receptacle cover.
SAVE THESE INSTRUCTIONS
.........................................
Installation
...................................................
Operation
3
Care and Cleaning ........................................8
Troubleshooting ........................................
3
3
3
□
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio ortelevision reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
□
Increase the separation between the equipment and receiver.
□
Connect the equipment into an outlet on a circuit different
□
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
□
help.
□
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
2
CAUTION:
The wire is intended for
shallow burial, less than 6 in. deep.
CAUTION:
10 ft. of a pool, spa or fountain.
The LEDs in this product are
CAUTION:
not replaceable.
CAUTION: Keep the lamp away from
materials that may burn.
5
8
9