Idiomas disponibles
Idiomas disponibles
Unpacking
NOTE: Before beginning assembly, make sure that all of
the parts and hardware listed below are present. If any part
is missing or damaged, do not attempt to assemble the
product. Contact the Snow Joe
department at 1-866-SNOWJOE (1-866-766-9563).
Parts
1. Screen hook
2. Protective screen
3. Log grid
Hardware
6. M6 ring screw
Assembling the Fire Pit
No Tools Required
Choose a soft and level location for assembly. Remove all
parts from the packaging, and check for missing parts.
1. Attach the M6 ring screw to the protective screen using
the M6 nut (Fig. 1).
Fig. 1
M6 ring screw
M6 nut
Hardware Used: M6 ring screw (x1)
Hardware Used: M6 nut (x1)
+ Sun Joe
customer service
®
®
4. Fire bowl
5. Cast stone base
7. M6 nut
Protective screen
2. Place all parts on the cast stone base (Fig. 2).
Fig. 2
Screen hook
Protective
screen
Log grid
Fire bowl
Cast stone
base
Care and Maintenance
Lighting
1. Make sure there is only a small amount of ash in the
bottom of the bowl.
2. Place a layer of dry kindling or a natural fire-starter onto
the center of the log grid.
3. Above the kindling or fire-starter, place a layer of dry
seasoned hardwood that is cut to lengths that are no
more than 3/4 the diameter of the bowl.
4. Use a match to light the kindling or fire-starter.
5. Using the screen hook that is provided and heat-resistant
gloves, replace the protective screen once the kindling or
fire-starter is lit.
4
