Idiomas disponibles
Idiomas disponibles
EN
Problem
The bar and chain
gets hot and
smokes.
The bar and chain
gets too hot and
can not cut.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3
seconds.
12
TECHNICAL DATA
Voltage
Guide bar length
Chain pitch
Chain gauge
Chain oil capacity
Weight (without battery
pack)
Chain
Guide bar
Battery model
Charger model
Possible cause
Solution
Oil tank is empty. Fill the oil tank.
1. Remove the
battery pack.
The discharge
2. Remove dirt
port is blocked.
from the dis-
charge port.
1. Clean the oil
tank.
Inlet opening of
inner oil tank is
2. Fill with clean
blocked.
bar and chain
lubricant.
The sprocket is
1. Clean the
stuck and clogged
sprocket.
with debris.
2. Fill with clean
bar and chain
lubricant.
The chain tension
Refer to Adjust
is too tight or too
the Chain Tension
loose.
in the manual.
Sharpen or re-
The chain is dull
place the chain.
Take out the chain
The chain is put
and turn it in the
on backwards.
right direction.
1. Release the
When you use the
trigger.
machine under
2. Start the ma-
load, it stops.
chine again.
Lubricate the
The chain is not
chain to decrease
lubricated.
the friction.
80V DC
10'' (254 mm)
1/4" LP (6.3 mm)
.050" (1.3 mm)
80 ml
9.57 lbs (4.34 kg)
25AP058X
100SDAA041
2901302/2902402 and other
BAB series
2901402 and other CAB
series
English
The recommended ambient temperature range:
Item
Appliance storage tempera-
ture range
Appliance operation temper-
ature range
Battery charging temperature
range
Charger operation tempera-
ture range
Battery storage temperature
range
Battery discharging tempera-
ture range
13
LIMITED WARRANTY
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-855-345-3934.
12
Temperature
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
39°F (4°C) - 104°F (40°C)
39°F (4°C) - 104°F (40°C)
32°F (0°C) - 113°F (45°C)
32°F (0°C) - 113°F (45°C)
