Idiomas disponibles
Idiomas disponibles
Engine Preparation
• Save all instructions
A
Engine Oil
CAUTION
Engine shipped without oil. Failure to add oil will result in
serious engine damage.
A bottle of SAE 30 engine oil is included with your blower.
Refer to the chart on the right for alternative oil types to
use at different temperatures. Always use a high quality
detergent oil classified "For Service, SG, SH, SJ" or higher.
Do not use special additives.
CAUTION
Always use recommended oil type.
incorrect oil type such as 2-stroke engine oil will shorten
engine life.
NOTE: Engine Oil Capacity is 562 ml. For first time fill, simply
add the entire contents of the provided oil bottle to the
crankcase.
HOW TO CHECK OIL LEVEL AND FILL TO PROPER LEVEL
WARNING
Before checking oil, make sure engine is off, and spark plug wire has been disconnected from spark plug.
1. Set walk behind blower on a level surface.
2. Remove the oil fill cap/dipstick and wipe clean with cloth.
(See Figure 3)
3. Insert dipstick into fill spout but do NOT screw in.
Remove dipstick and check oil level.
4. When oil level is full, the oil will be at upper limit on dip
stick. If oil level is near or below the lower limit, oil must
be added. (See Figure 4)
5. Add oil slowly until the oil level reaches the upper limit of
the dipstick. Use a funnel or nozzle to reduce spillage.
CAUTION
Frequently check oil level while filling. DO NOT OVERFILL.
DO NOT UNDERFILL. Running engine at improper oil level
will seriously damage engine.
6. Replace and tighten dipstick.
7. Clean up any spilled oil.
Questions? Call Toll Free at 1-800-737-2112
SAE
Using dirty oil or
TEMP
7
SAE 10W-30
-20
20
0
-30
-20
-10
0
Ambient Service Temperature
Upper Limit
Lower Limit
Copyright © 2009 MAT Engine Technologies, LLC
SAE 30
60
80
100° F
40
10
20
30
Fuel Tank Cap
Oil Fill Cap/
Dipstick
Figure 3
Oil Fill Cap/
Dipstick
Figure 4
40° C
