Driving and removing screws
e direction reversing switch to position 'L' in order to drive screws.
e the torque adjustment ring to the drilling position.
Ensure that the direction reversing switch (5) is always set to 'L' during drilling.
5
Switching the device on and off
elease the on/off switch to halt the drill chuck immediately which will no longer run on.
e direction reversing switch to the centre in order to lock the appliance in its disabled state.
Only lay down the appliance when it has stopped running completely. Do not place it on a dusty surface as
particles of dust could get into the mechanism.
6
Speed Control
The drill has a 2-speed gearbox and the speed selector is located on the top of the
drill. First gear has a range of 0-350/min and the second gear has a range of
0-1100/min. the speed can be varied from 0 to maximum in switch. This way you can
select the best possible speed for the job required
LED Lights
The drill has 1 LED light built into the unit. The LED light is located above the
variable speed switch.
The LED light turns on automatically when you depress the variable speed switch.
The LED light illuminates dark areas in tight corners to assist with drilling and screw
driving. This helps achieve a more accurate result in your work piece
Charging the battery
Charging
Cordless drill/driver MPCD14VDQF/2 User Manual
L
. It regulates the speed of the appliance by transmitting power to the switch.
charged condition.
'R' in order to remove screws. Drilling
Stop
.
range between + 5 °C to + 40 ºC.
rooms.
GB
R
7
8
8
