Idiomas disponibles
Idiomas disponibles
11. SAFETY LOCK-OFF.
12. LOCK KNOB OF AUXILIARY HANDLE.
13. AUXILIARY HANDLE.
13
12
7
6
5
2
TECHNICAL DATA
DE512
VOLTAGE-FREQUENCY
NO LOAD SPEED
CUTTING CAPACITY
NYLON DIAMETER
POWER CONSUMPTION
POWER
WEIGHT
ASSEMBLY INSTRUCTIONS
ADJUSTMENT OF THE GUARD AND CUTTING
GUIDE
1. Rotate the fixed trestle, Using 2pcs ST4 x 14
screw to install edge guide (fig.1.2)
2. Hold the machine shelf, fitting the protective
cover in the machine shelf (fig.1.1).
3. Align the protective cover and the machine
shelf together with 4pcs ST4 x 14 screw.
2.
1.
Fig. 1
TELESCOPIC HEIGHT
ADJUSTMENT
Loosen the union nut
until the grass trimmer
handle can move in and
out freely (fig.2).
10
11
10
9
8
1
4
3
127 V ~ 60 Hz
10 000 r/min
12" (30 cm)
1,4 mm
450 W
0,45 kWh
2,2 kg (4,9 lb)
3.
Fig. 2
Now adjust the required working height and
secure the handle in this position by tightening
the union nut again.
ADJUSTING HANDLE
To adjust, press both
buttons that hold the
handle and put it to a
desired location (See
Fig. 3).
OPERATION INSTRUCTIONS
OPERATION OF THE TRIMMER
NOTE: Remove the blade guard before starting
operation.
1. To turn the trimmer ON press the trigger
switch. To turn OFF, just release the trigger.
2. Let it run for a few seconds without touch-
ing the work area, allow the machine to cut the
nylon to the correct length.
3. When operating the
trimmer hold it at an an-
gle of about 20 degrees
above ground level (Fig.
4). Swing the trimmer
from side to side to make
an even cut (Fig. 5).
HEADCUT
The head of the trim-
mer is set an angled
position
adjusting to
the cutting area.
Press
the
button
showed in Fig. 6 to set
and angle.
DURING OPERATION
Do not overload the trimmer, cut small sections
to improve cutting efficiency, keep it running at
high speed. (Fig. 7)
Fig. 3
20º
Fig. 4
Fig. 5
Botón
Fig. 6
