Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. flow rate: 1.2 GPM (4,542 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Chrome finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Place new faucet through holes
in top of sink. From underside,
slide mounting nuts onto threaded
rods. Secure with washer and
nuts.
3. Connect water supply lines.
(1) Use 1/2" IPS faucet supply
lines or (2) use coupling nuts
(not supplied) with (3) ball-nose
risers (not included).
Turn water supply or shut-off
valve back on and check for
leaks. If leaks occur, gently
tighten the faucet connections.
4. POP-UP DRAIN
INSTRUCTIONS:
Remove flange from pop-up main
body. Leave large black washer
(not included with plastic pop-ups)
and nut on drain body.
NOTE: Images or drawings may vary from actual product.
www.homewerksww.com
1
2
3
3
1
2
4
SPECIFICATIONS
1/4-turn washerless cartridges
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
Total weight of item: 1.91 lbs.
5. Add PTFE pipe tape to the
threads on the drain body.
Add Plumbers Putty to bottom
of flange per manufacturers
directions. Insert threaded end
of drain body up through drain
hole and attach flange to body
with ball rod pointing to the rear
of the sink. Tighten the flange.
6. Unscrew the nut from the pop-
up body and take off the spring
clip from the ball rod (Please
note: The white packing ring
must remain on the ball rod)
Place the nut on the ball rod.
Insert the ball rod onto the side
hole of drain, slide the nut on
and tighten securely.
7. Thread locknut from underside
of sink until rubber washer seats
securely inside opening of sink.
Tighten locknut. Wipe off excess
putty. If model has plastic wing
nut, tighten securely. If nut is
brass, tighten with a wrench
8. Place one end of spring clip
on end of ball rod. Insert rod
across and through hole in lift
rod strap. Secure other end.
2
5
6
7
8
