Idiomas disponibles
Idiomas disponibles
10. Once you have reviewed the initial results, you can scroll through screens to
display a graphical representation of the battery's state of health and state of
charge (by pressing the right key in either direction).
11. Remove the test leads from the battery posts after completion of testing, always
removing the negative clamp first and then the positive clamp.
System Testing: Starting and Charging System Tests
During this portion of the testing process, the tester will perform the following tests in
order:
• Starting System Cranking Test
• Charging System Test without Loads
• Charging System Test under Loads – Ripple Detect
• Charging System Test under Loads
Please follow the instructions below to run through the above testing steps.
1. Make sure the battery terminals are clean. See Preparing Battery to be Tested.
2. Connect tester leads to the battery, clamping the red (pos) clamp to the vehicle
positive battery terminal first. Then, clamp the black (neg) clamp to the vehicle
negative battery terminal second.
Note: Whenever possible, connect directly to the terminals/posts of the battery.
3. Upon completing a proper battery connection, the tester display will show the
Home Screen. Select SYSTEM TEST, scrolling as needed to bring the indicator in
line with SYSTEM TEST. Press "ENTER".
4. The tester will prompt you to turn off all vehicle accessory loads such as lighting,
air conditioning, radio, etc, and start engine.
5. Start the engine. The display will show the minimum voltage reached by the
battery and provide an assessment of starting system condition. Assessment
corresponds as follows:
CRANKING VOLTS NORMAL – Starting System is showing normal draw.
CRANKING VOLTS LOW – Starting System is Weak – check manufacturer
specifications and troubleshoot starter as per recommended procedure as needed.
CRANKING VOLTS NOT DETECTED – Check connections, wiring, and starter
immediately.
