Idiomas disponibles
Idiomas disponibles
NOTE:
• If no button is pressed within 10 seconds. The newly set tem-
perature will be stored.
• The temperature setting range from 2°C to 6°C. The actual
temperature inside the appliance can be affected by the am-
bient temperature.
• Keep the door open time as short as possible in order to keep
a cool temperature inside.
2). Illumination inside the cabinet
• Press Illumination to switch ON the light. Press Illumination
again to switch OFF the light.
3). Refrigerant LED indicator
• During the cooling operation (compressor enabled), this re-
frigerant LED indicator will lights up constantly.
• After the inside cabinet reach the set temperature, the refrig-
erant LED indicator will flashes continuously.
• When defrost start, the refrigerant LED indicator light off.
4). Defrost LED indicator
• During the defrost operation, this defrost LED indicator will
lights up constantly.
• After the defrost operation, defrost LED indicator will lights
off.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for cleaning.
Do not use petrol or solvents!
• No parts are dishwasher safe.
Parts
How to clean
All accessories
• Soak in warm,
such as rack
soapy water for
holders, etc.
about 10 to 20
minutes.
• Rinse under
running water
thoroughly.
External glass
• Wipe clean with
surfaces
a soft cloth and
a little neutral
detergent. Make
sure no water or
moisture enters
inside the of the
appliance.
Interior glass
• Remove any food
surfaces
deposits.
• Wipe clean with
Glass door
a soft cloth and
a little mild
detergent. Make
sure no water or
moisture enters
inside the of the
appliance.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
Remark
GB
Dry all parts well
at last.
9
