Idiomas disponibles
Idiomas disponibles
Vercise™ DBS Physician Manual
Note: The Charging Collar can be placed under or over clothing. You should not wear
tight fitting or heavy clothing over the Charger while charging to allow air flow
around the Charger.
Using the Adhesive Patch
1. When the indicator light is green, remove the Charger from the Base Station.
(The indicator light will go off, regardless of the ready status of the Charger.)
2. Apply the Adhesive Patch to the backside of the
Charger by peeling the clear liner from the patch
and applying the white side with the blue stripe
to the rear of the Charger, as shown to the right.
3. Remove the skin side beige liner from the
adhesive (only good for one fixation.).
4. For best charging results, make sure the Charger
is centered over the Stimulator. If the Charger is
not centered, charging time may increase. See "Properly Aligning the Charger" on
page 43 to ensure you center the Charger over the Stimulator.
WARNING: Do not put the Charger directly on the skin (e.g., without an Adhesive
Patch). This may result in uncomfortable heating of the skin or a burn.
Vercise™ DBS Physician Manual
91098825-11
42 of 341
