Idiomas disponibles
Idiomas disponibles
3
Install new LUTEC LED bulb and the Diffuser (A1) by rotating each clockwise. Turn ON the switch.
CARE AND MAINTENANCE
To clean, wipe with a damp, non-abrasive cloth.
TROUBLESHOOTING
PROBLEM
The light will not go on.
The fixture shakes in high
winds.
The lights come on during
the daylight.
A1
POSSIBLE CAUSE
1. Switch OFF.
2. The battery is completely
discharged.
3.
DUSK TO DAWN activited.
4.
The bulb is loose.
5. Interference from other light
source.
6. The battery is not charged
1. The mounting bracket could
be loose.
2. The insert may be loose.
3. The screws and cap nuts
may be secured incorrectly.
1. The light may be installed
in a dark location.
4
CORRECTIVE ACTION
1. Set to ON.
2. Charge for 6-8 hours in direct
3.
4.
5.
6. Make sure the solar panel is in
1. Make sure the mounting
bracket screws are tightened.
2. Make sure the insert is
assembled completely and
tightly.
3. Make sure the screws and cap
nuts were secured tightly.
1. Relocate to sunny location.
12
OFF ON
OFF ON
sunlight.
Check at night.
Re-tighten the bulb.
Relocate the solar post light.
direct sunlight.
