Idiomas disponibles
Idiomas disponibles
ENGLISH
FR U I T I C E C R E A M
Place the auger and the fruit ice cream filter in the
juicing bowl and close the lid.
Insert the fruit ice cream filter into the juicing bowl
while aligning the red dots
of the fruit ice cream filter
and the juicing bowl. Insert the auger into the fruit ice
cream filter with a twisting motion. Place the lid onto
the juicing bowl by aligning the red dots
and the juicing bowl. Then, rotate the lid clockwise
until the lid is secured.
When using the blank strainer, always leave the anti
drip tap open. Before use, make sure the silicone cover
is correctly in place.
S OR B E TS
Use the fruit ice cream filter and assemble as above
Take frozen fruit out the freezer and thaw at room temperature for 15 minutes. Feed
into the juicer and enjoy frozen sorbet! Remember to always leave the fruit to thaw
as to not damage your juicer.
N U T MI L K
Using almond or cashew nut milk instead of dairy is a fantastic idea and really
simple to do with your new juicer. Assemble the juicer and use the juice filter,
just like you were going to make juice.
Soak nuts such as almonds overnight in a bowl. The next day replace the water
with fresh water.
Run the nuts along with the fresh water using a ladle into the juicer for delicious nut
milk!
10
of the lid
f1900 FRIDJA WHOLE FRUIT SLOW JUICER
HOW TO D I SAS SE M BL E A N D C L E A N
Switch OFF and unplug the power cord from the wall outlet. Extract all the
remaining pulp in the juicing bowl before stopping the juicer. For easier clean up,
operate the juicer for an additional 30 seconds after the juice is extracted.
When the drum lid is stuck, press the REVERSE - OFF - FORWARD button in this
order, switching back and forth 2 to 3 times to dislodge. Then place hands on top
of the drum lid and firmly press down simultaneously turning the drum lid counter
clockwise to open.
Lift the bowl on the base so that its grey arrow lines up with the black arrow on the
base. Remove the juicing screw/auger, strainer, and rotation wiper unit from the
juicing bowl. Clean with provided brush.
Immediately clean the juicer after each use. If remaining residue in the juicer dries
up, it can make disassembling and clean-up difficult. The excess build up can cause
poor performance in future uses.
For easier disassembly, place the top-set in the sink and run the water through from
the top of the top-set. Place the juicing bowl under running water and unplug the
compression silicone to clean the pulp spout. Soak the juicing bowl in a solution of
warm water with baking soda to clean the excess build-up.
The silicone wipers are removable for cleaning. After cleaning, place the silicone
wipers back onto the frame. Insert into the slot with the tail pointing down.
T R O U B LE S HO OT I N G Q &A
When there is no power to the juicer:
•
Check if the power cord is properly plugged in.
•
Check if the drum lid and the juicing bowl are properly assembled. Watch the
video on how to assemble! It won't turn on if assembled incorrectly.
•
When the juicer stops because there are too many ingredients inserted in it,
press the REVERSE-OFF-FORWARD button in this order, switching back and
forth 2 to 3 times.
•
If the juicer stops due to the overload protection, let the juicer cool for 30
minutes to 2 hours before juicing again.
11
