Idiomas disponibles
Idiomas disponibles
Keep hands and feet clear of the jack hinge mechanism and ground contact area when lowering the
load!
HANDLE ASSEMBLY
• Prior to assembly please remove the clip attached to the handle socket (picture 1). This piece it's
there for shipping purposes only and is not part of the jack.
• Refer to picture 2 when performing this step. Push in the Spring Button located on handle piece "a"
and insert handle "a" into handle "b". Please watch your fingers while performing this step, being
careful not to get pinched.
• Fully unfasten the screw located in the Handle Socket to insert the assembled handle (picture 3).
• Line up the square hole located at the bottom of the handle over the square bolt inside the Handle
Socket.
• Secure the handle in place by tightening the screw in the Handle Socket.
Handle (b)
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
THIS JACK IS A LIFTING DEVISE ONLY
This Jack is designed only for lifting parts of the total vehicle.
Do not move or dolly the vehicle while it is on the jack.
Pic.2
Handle (a)
Spring Button
Tel.: 02196 720480
Fax.: 02196 7204820
Pic.1
Press
Handle Bottom
www.bgstechnic.com
Pic.3
Screw
© BGS technic KG, Copying and further use not allowed
