Idiomas disponibles
Idiomas disponibles
■ STOPPING ENGINE
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the STOP position.
NOTE
•
Except for an emergency, avoid stopping the
engine while pulling the throttle lever.
■ TRIMMER HEAD USAGE
WARNING
1. Always wear eye protection such as safety
goggles. Never lean over the rotating cutting head.
Rocks or other debris could be thrown into eyes and
face and cause serious personal injury.
2. Keep the debris guard attached in place at all
times when the unit is operated.
TRIMMING GRASS AND WEEDS
NOTE
•
Always remember that the TIP of the line does
cutting. You will achieve better results by not
crowding the line into the cutting area. Allow the unit
to trim at its own pace.
1. Hold the unit so the head is off the ground and is
tilted about 20 degrees toward the sweep direction.
2. You can avoid thrown the shield by sweeping from
your right to the left.
3. Use a slow, deliberate action to cut heavy growth.
The rate of cutting motion will depend on the
material being cut. Heavy growth will require slower
action than will light growth.
4. Never swing the unit so hard as you are in danger
of losing your balance or control of the unit.
5. Try to control the cutting motion with the hip
rather than placing the full workload on the arm and
hands.
6. Take precautions to avoid wire, grass and dead, dry,
long-stem weeds from wrapping around the head
shaft. Such materials can stall the head and cause the
clutch to slip, resulting in damage to the clutch
system if repeated frequently.
12
