Idiomas disponibles
Idiomas disponibles
10. Light Kit Assembly (Optional).
Remove 1 screw from motor plate (on underside
of motor) and partially loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist fitter
plate to lock. Re-insert screw that was just
removed and tighten all 3 screws securely with a
Phillips screwdriver .
Remove 1 screw and partially loosen the other 2
screws from underside of fitter plate.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLUE (or
BLACK) wire from motor housing to BLUE wire
from LED light kit. Be sure molex connections
snap together securely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened
screws in fitter plate. Twist LED light kit to lock.
Re-insert screw that was previously removed and
tighten all 3 screws securely .
If you wish to USE the light kit, align grooves on
shade with nodules on inside of fitter plate and
push up gently on shade. Twist shade to the
RIGHT (clockwise) until shade locks into place.
Pull down VERY GENTLY on shade to make sure that
shade is secure.
If you do NOT wish to use the light kit,
slots on metal cover and align with nodules
inside fitter plate. Gently push up on metal cover
and turn to the
RIGHT (clockwise)
longer turns.
WARNING: Metal cover will be HOT if light is left
on.
locate
until it no
page 9
motor
plate
molex
connections
LED
light kit
fitter plate
shade
fitter plate
metal cover
motor
housing
fitter plate
motor housing
fitter plate
molex
connections
motor housing
nodules
grooves
motor housing
nodules
grooves
