11. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the wall
control but do not wish to use the handheld remote control,
please proceed to Section 11.
Gently pull on remote control cover to separate top and
bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote control,
cut each wire on wall control (that was not previously
used)--use wire cutters to cut off each wire as close to
the wall control as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall control.
[Refer to diagram 2.]
WARNING: Battery is to be inserted with the correct
polarity.
Attach black faceplate to front of wall control; press
down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on inside
of TOP part of remote control cover and press together
firmly. Place wall control into BOTTOM part of remote
control cover, aligning posts in top of remote control
cover with post holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and bottom
of remote control cover together until you hear a click
at each end, indicating that the remote control cover
has closed completely.
IMPORTANT: Store the handheld remote control away
from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if handheld
remote control will not be used for long periods.
NOTE: Remove batteries with low or no charge and
dispose of properly.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK. " - When disposing of
household alkaline batteries, it is best to check with your
local and state recycling or household hazardous waste
coordinators concerning the specifics of the program in
your area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or www.earth911.org
for more information.
WARNING: Choking Hazard - Small parts. Keep batteries
away from children.
WARNING: Batteries are NOT rechargeable.
Non-rechargeable batteries are not to be recharged.
diagram 1
diagram 2
post
hole
remote control
cover, BOTTOM
diagram 3
page 10
remote control
cover
(top)
(bottom)
wall control
wire
-
1 1
-
2 2
wire
wire
12V battery
hole
-
1 1
-
2 2
face-
plate
wall
remote control
control
post
cover, TOP