Idiomas disponibles
Idiomas disponibles
Nozzle Maintenance
The Whirl-A-Way comes with two 25° nozzles that have an orifice size
of 015. They are installed and aligned properly during production. To
confirm proper alignment, inspect the nozzles. The indent line of the
nozzle has to be in line with the rotary arm. If they are out of alignment
the resulting spray angle will result in striping with the possibility of the
rotary arm not spinning at all.
If there are any performance issues, including vibration, pulsing, or
stripping, then it is very likely the nozzles are damaged or clogged.
Always turn off the pressure washer and detach the Whirl-A-Way when
performing any inspection or maintenance.
1.
If the nozzle struck any hard object it can be damaged. If the
metal nozzle is deformed it will need to be replaced.
2.
If there is no damage, then it is likely the nozzle is clogged.
3.
To clean, remove the nozzles. Use CAUTION when removing the
nozzles as trapped pressure may be suddenly released.
4.
Use the included cleaning tool (or a fine metal wire) to remove
any debris or foreign material that has built up in the nozzle.
5.
Use water to back flush the nozzle. (Run the water through the
nozzle in the opposite direction the water would normally spray
out).
6.
Use Teflon tape or paste on the threads to prevent leaks when
reinstalling.
7.
Install nozzles back on. Ensure the indent on the nozzles are in
line with the rotary arm.
8.
Reconnect your pressure washer and start.
9.
Always flush the Whirl-A-Way with clean water after use, espe-
cially if soaps or detergents were used.
10. When not in use, make sure water has been drained from the
Whirl-A-Way to prevent freezing damage.
Nozzle Cleaning Tool
Part # 85.211.008
6
NOZZLE MAINTENANCE
