Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SAFETY GUIDELINES
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
NOTICE:
Indicates a practice not related to personal injury which, if not avoided, may result in property damage.
READ ALL INSTRUCTIONS
WARNING: Read all instructions before using the light. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
• Changes or modifications to this unit not expressly approved by the manufacturer could injure the user, cause damage to the unit,
and void the Warranty.
• Consult a qualified electrician if you are not certain about the installation process. Always install wiring connections in accordance
with local code, ordinances and the National Electric Code.
• This light fixture is designed to fit standard junction boxes as defined by the National Electrical Code.
INSTALLATION 1
1
2
4
5
3
6
2
WARNING: Make sure the power is off.
1.
Unscrew the bottom screws.
2.
Loosen the pre-assembled hex nut screwed onto the threaded nipple.
3.
Attach the mounting plate to the junction box using the screws.
Connect the white wires from the fixture to the white wires from the supply circuit, the black wires from fixture to the black wires
4.
from the supply circuit, and the ground wire (green) from the supply circuit using the wire connectors .
5.
Attach the photocell to the fixture by turning it clockwise.
6.
Apply silicone caulk (not included) completely around the perimeter of the fixture where the back plate meets the mounting surface
to prevent water from seeping into the junction box.
INSTALLATION 2
1
2
4
WARNING: Make sure the power is off.
1.
Using the bottom of the fixture arm, mark 3 points on the surface of the desired mounting location.
2.
Connect the white wires from the fixture to the white wires from the supply circuit, the black wires from fixture to the black wires
from the supply circuit, and the ground wire (green) from the supply circuit using the wire connectors .
3.
Install the 3 mounting screws and washers on the bottom of the fixture arm. Place the fixture arm on the two bottom screws and
install the third screw. Tighten the 2 bottom screws to secure the fixture.
4.
Attach the photocell to the fixture by turning it clockwise.
3
3
Tabla de contenido
