Idiomas disponibles
Idiomas disponibles
4.
Protection against manipulation
Your system consists of 2 electronic devices:
„
„
Code keypad
„
„
SECUREconnect 200 (control unit)
The code keypad is generally installed externally (on the outside of the
door). To prevent unauthorised access, your system is equipped with numer-
ous security functions:
„
„
The code keypad is connected to the control unit using a data cable.
Data transmission is encrypted.
„
„
The code keypad and control unit are clearly coupled together for initial
commissioning (pairing).
The code keypad records the PIN code with the capacitive keypad, and com-
pares the entered data with the stored reference codes. The code keypad
can process PIN codes comprising 4 up to 8 digits. The PIN code must not
consist solely of identical numbers. There are 2 types of PIN codes: the ad-
min code for configuring the system and the user code for opening the door.
If you enter the code incorrectly 3 times, you will be locked out of the
system for 1 minute. If you enter the code incorrectly 3 times again, you will
be locked out for 15 minutes. Subsequently, you will be locked out for 15
minutes each time you enter the code incorrectly. The lock can be reversed
before it is due to end by entering an authorised user code twice.
In order to exchange a component of the door system (SECUREconnect 200R,
SECUREconnect 200F or code keypad), you have to start a re-pairing proce-
dure. To do so, close the reset contact on the board of the SECUREconnect 200F
or SECUREconnect 200R for a minimum of 3 seconds with the power supply
connected. We recommend the use of an alligator clip for this purpose.
Afterwards, remove the clip. The pairing process for the SECUREconnect 200R,
SECUREconnect 200F and code keypad now restarts, and the code keypad is
reset to the factory setting.
27
