Idiomas disponibles
Idiomas disponibles
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: To prevent overheating, the heater blows
HEATER
cool air for 30 seconds before the heater turns
on, and after it turns off.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and should
not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the
buttons too quickly. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the
heater will automatically turn OFF. To reset:
1.Unplug the power cord from the outlet.
2.Turn the ON/OFF switch on the TOUCH PANEL to OFF. Wait 5 minutes.
3.Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a
vacuum to clean the vent areas.
4.With the POWER switch in the OFF position, plug the power cord back into the outlet.
5.If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
Remote control uses one CR2025 battery ( Included)
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an explosion.
Dispose of batteries at your local hazardous material processing center.
6.Care and Maintenance
Cleaning
1. Press once. LED Indicator lights up. Continue
press Fan blows cool air for 30 seconds. Then
Low heater turns on and blows warm air.
2. Press again. LED Indicator lights up.
High heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air, then turns off.
16
