EN
1
DESCRIPTION
1.1
PURPOSE
The machine is intended for hammer drilling in concrete,
bricks and masonry, as well as for light chiselling work. It is
also suitable for drilling without impact in wood, metal,
ceramics and plastic, as well as for screwdriving.
1.2
OVERVIEW
1
5
2
SDS Chuck
1
Mode Selector
2
Forward / Reverse
3
2
GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
2.1
WORK AREA SAFETY
•
Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
•
Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes.
•
Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.
•
The machine is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
Trigger
4
LED Light
5
WARNING
English
knowledge, unless they have been given supervision or
instruction concerning use of the machine by a person
responsible for their safety. Children should be
supervised to ensure that they do not play with the
machine.
2.2
ELECTRICAL SAFETY
•
Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs
with earthed (grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric shock.
•
Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock
3
if your body is earthed or grounded.
•
Do not expose power tools to rain or wet conditions.
4
Water entering a power tool will increase the risk of
electric shock.
•
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges and moving
parts. Damaged or entangled cords increase the risk of
electric shock.
•
When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
•
If operating a power tool in a damp location is
unavoidable, use a RESIDUAL CURRENT DEVICE
(RCD) protected supply. Use of an RCD reduces the risk
of electric shock.
2.3
PERSONAL SAFETY
•
Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a
power tool while you are tired or under the influence
of drugs, alcohol or medication. A lapse of attention
while operating power tools may result in serious
personal injury.
•
Use personal protection. Always wear eye protection.
Protective products such as dust mask, non-skid safety
shoes, hard hat or hearing protection used appropriately
will reduce personal injuries.
•
Prevent unintentional starting. Ensure the switch is in
the off position before connecting to power source
and/or battery pack and when picking up or carrying
the tool. Carrying power tools with your finger on the
switch or energizing power tools that have the switch on
invites accidents.
•
Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to a
rotating part of the power tool may result in personal
injury.
•
Do not over-reach. Keep proper footing and balance
at all times. This enables better control of the power tool
in unexpected situations.
•
Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves away
4