Idiomas disponibles
Idiomas disponibles
EN
8.3
INSTALL SANDPAPER
The cushion on the sander gives you the option of
using either non-adhesive sandpaper that clamps to
the platen or adhesive backed sandpaper with pressure
sensitive adhesive backing that sticks to the cushion.
1. Remove the battery pack.
2. Inspect sandpaper before installing; do not use if
broken or defective.
3. If replacing sandpaper, remove old sandpaper. To
remove paper, release paper clamp by lifting up on
lever, and disengaging it from the tab on the platen.
4. Insert end of new 1/4 sheet sandpaper
approximately 1/2 in. under the paper clamp.
5. Lift up on paper clamp lever and lock into place.
Apply downward pressure to conform sandpaper to
platen.
6. Wrap sandpaper around cushion. Lift lever on
opposite end of sander and insert loose end
of sandpaper under paper clamp. Fit sandpaper
against cushion tightly.
7. Lift up on lever and lock into place.
1/2 in. clamping of sandpaper is necessary for multi-
sheet stacking of paper.
NOTE
English
8.4
PAPER PUNCH
A paper punch template has been supplied with the
sander for aligning and punching holes in sandpaper.
The punched holes must align with the holes in the
sander cushion. Punching the holes properly is a
necessary step for dustless sanding.
1. Install sandpaper on the sander.
2. Align sander cushion to paper punch as shown.
3. Push down on sander.
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury. If the sanding operating is
dusty, also wear a face or dust mask.
8
NOTE
