Idiomas disponibles
Idiomas disponibles
2. Attach keyboard tray to mount using four M5 x 12 mm
bolts. Tighten using Phillips screwdriver. Insert four
caps to cover bolts. (See Figure 2)
Figure 2
M5 x 12 mm Bolt
3. With a second person, align keyboard tray in
desired position. Attach unit underneath the desktop
using a drill and four wood screws. (See Figure 3)
NOTE: It is recommended to position the unit
so the front edge of the keyboard tray is flush
with front edge of desktop when fully retracted.
Keyboard tray needs to be extended to attach.
NOTE: If desired, pilot holes can be created
using a drill and a 4 mm drill bit. The pilot holes
should go no deeper than 9/16".
Figure 3
PAGE 2 OF 9
ASSEMBLY CONTINUED
Cap
Keyboard Tray
Desktop
Flush
Wood Screw
WITH BRACKETS
1.
With both brackets angled outward, attach brackets
to track with four M5 x 8 mm bolts. Tighten using
Phillips screwdriver. (See Figure 4)
NOTE: Bracket orientation below is compatible
with most desks. If necessary, brackets can be
angled inward.
Figure 4
Track
M5 x 8 mm Bolt
2. Attach the mount to the track using four
M5 x 8 mm bolts. Tighten using Phillips screwdriver.
(See Figure 5)
Figure 5
Track
Mount
Bracket
M5 x 8 mm Bolt
0522 IH-10033
