Skymsen SF-282 Manual De Instrucciones página 4

Ocultar thumbs Ver también para SF-282:
Idiomas disponibles

Idiomas disponibles

Before to start the machine
Place the product to be cut on the Fixed Table.
Choice the slices thickness and adjust the Thickness Guide
No. 04 (Pic.01).
Adjust the Blade Guide No. 12 (Pic. 01) to no more than the
height of the product to be cut.
Stay in front of the machine to have a front sight of the
Blade.
Start the Machine
To start the machine turn the ON/OFF Switch button "I"
(ON).
Catch the product with the left hand and push against the
Blade cutting the product at constant speed.
After finishing the whole slice remove it with the right hand.
The slice shall ALWAYS be removed behind the Blade to
avoid the hand to contact the Blade.
Place the slices upon the Fixed Table No. 05 (Pic. 01).
Bring back the product to the front side of the machine and
repeat the above steps until to have finished to cut it all.
After the end of the last slice turn the ON/OFF Switch to the
position "O" (OFF) No. 13 (Pic. 01).
Follow below instructions to remove the
above mentioned components:
Door
Turn the two Door handle counterclockwise
until they get free from their screws. Open
the Door No. 01 (Pic. 04) grab it strongly
and lift the Door.
Table Block
Remove the Fixed Table Block No. 01 (Pic.
04) just lifting it, see picture 05.
4
5. CLEANING
When the equipment must go through a complete cleaning
and sanitization process:
- Before to be used first time.
- After every day end of operations
- When the saw is not going to be used for a long period.
- Before to start operation after a long period it has not been
used.
Some components may be removed to clean:
- Door;
- Table Block;
- Blade;
- Upper Wheel.
Picture 04
01
Picture 05
01
loading

Este manual también es adecuado para:

Sl-282Sf-295Sl-295