Idiomas disponibles
Idiomas disponibles
Pressing the heating level button (e) again turns off the heating, ventilation stops
after approx. 30 seconds and the device goes into standby mode.
The function of the timer button (c) works in the same way as from the control
panel (see the description above).
The air supply flap button (b) switches it on or off by pressing it. In the
UNI_HEATER_09 model, the activation of the flap is confirmed by the
corresponding indicator on the control panel - the same icon as on the button of
this function on the remote control.
3.3.5 Setting the day/time
IMPORTANT: day/time settings can be changed both in standby mode and during
operation.
•
Press the time and day setting button (d) on the remote control, and the
display will show the default value, e.g. "12."
Use the parameter decrease/increase (f/h) buttons to set the current hour
•
(selection range 0-24).
•
After setting the hour, press the time/day button (d) again to move to the
minute setting and use the parameter decrease/increase buttons (f/h) to
set the current minute (selection range 00-59).
•
As soon as you set the time, press the button used for setting the time and
day (d) to choose the current day of the week. The display will show the
message "d1", where:
d1 = Monday; d2 = Tuesday, d3 = Wednesday, etc. until Sunday = d7.
Set the current day of the week using the buttons for
decreasing/increasing the value of the parameter (f/h). Then use the
button for confirming the value (g) to approve the selected values. The
display will revert to showing the previous information as before changing
the settings.
For example, if we set Wednesday, 9:30 a.m., heating at 25
power, the setting diagram will look like this for a given model:
o
C with high
