Idiomas disponibles
Idiomas disponibles
right material and diameter you are welding with. Adjust current according your workpiece thickness.
To find the best welding performance and suitable for your welding habits. You may also adjust voltage and inductance to build a perfect welding bead and
penetration.
"Spool gun torch" welding
This machine can be connected to a "Spool gun torch". (package does not include a "spool gun").
The use of "Spool gun torch" is similar to that of MIG torch, except that the wire is fed through the wire feeding mechanism of the "spool gun"torch itself. In
the"spool gun"mode, the feeding mechanism of the original machine does not work.
Select "spool gun" mode on the front control panel or turn on the "Spool gun" switch at MIG mode. (This toggle switch is in the wire feeding warehouse of
the machine or near the "Mode" button). Aluminum welding is supported in "spool gun" mode.
Solid Wire
flux cored wire
Operation of LIFT TIG function
Please follow installation draft to install the TIG torch and earth clamp. In Lift TIG welding mode, adjust 【 Current adjusting knob 】 The welding current can be
changed. The welding current range is 30A to maximum current 150A adjustment.
TIG welding function are for thin workpiece welding or stainless steel welding. Usually choose Ar gas as protecting gas.
1 ， Connect the gas hose with gas tube on torch.
2 ， Connect the TIG torch on negative plug.
3 ， Connect the Earth cable on positive plug.
Fault display ： OC light
When the welding load is overloaded and the output current of the machine is too large, the internal temperature of the machine is too high, and the
machine fault light will be on. This is normal. The machine can recover after the heat dissipation becomes normal. Please restart the power supply; When
damaged, the fault light will be on, in this case, the machine is abnormal and needs maintenance, please contact the supplier.
3.3 Polarity conversion joint
This machine has the polarity conversion; There are positive output terminal and negative output terminal between wire feeder and wire spool; When use
solid wire with gas protection, torch socket should be connected to the positive output terminal, ground cable should be connected to the negative output
terminal; When use flux-cored wire, the ground cable should be connected to positive terminal.
3.4 Welding environment and safety
Working surrounding
a)Welding should be carried out in dry surroundings. The air humidity level should not be higher than 90%.
b)The temperature should be between -10C to 40C.
c)Don't use the welding machines in sunshine or rain. Keep it off water.
d)Don't use the machines in the places of dust or corrosive air.
e)MIG welding should not be carried out in places with quick air flow.
Safety norms
Protection circuit of over-voltage, over-current and over-heat circuits are designed in the welding machines. It will stop working automatically when the
input voltage, output current or internal temperature exceed the rated value. But if the machines are excessively used, such as with input voltage higher
than the rated, the machine might be damage. Please pay close attention to the following matters.
Keep good ventilation!
The welding machines work with high welding current. Nature air flow can't reach the requirement of heat dissipation. So the fans are installed as cooling
system to ensure stable performance.
Make sure the ventilation windows are not covered or blocked. The distance between the machines and things around should not be less than 0.3m. Good
ventilation is good for welding performance and operational life.
Never over load!
35
